Recommend:
Knowledge document #3388

Unable to access the internet over a VPN connection

Although the VPN connection to the FRITZ!Repeater was successfully established, you cannot access the internet over the connection. While the VPN connection is active, the device either cannot access the internet or still sends all web requests directly to the internet and not over the VPN connection to the FRITZ!Repeater.

Simply proceed as described below. After each measure, check whether the problem is solved.

Note:All instructions on configuration and settings given in this guide refer to the latest FRITZ!OS for the FRITZ!Repeater.

1 Restarting the FRITZ!Repeater

You may be temporarily unable to correctly establish the VPN connection due to an error in the FRITZ!Repeater or its internet connection. Therefore, restart the FRITZ!Repeater so that it reinitializes the firewall and re-establishes the internet connection:

  1. Click "System" in the user interface of the FRITZ!Repeater.
  2. Click "Backup" in the "System" menu.
  3. Click on the "Restart" tab.
  4. Click the "Restart" button.

2 Adjusting the VPN settings of the FRITZ!Repeater

If you connected two FRITZ! networks via IPSec (LAN-LAN linkup), the option "Send all network traffic via the VPN connection" must be enabled so that web requests are forwarded to the remote FRITZ! network:

  1. Click "Internet" in the user interface of the FRITZ!Repeater.
  2. Click "Permit Access" in the "Internet" menu.
  3. Click on the "VPN (IPSec)" tab.
  4. Click the (Edit) button next to the respective VPN connection.
  5. Enter the password required to establish the VPN connection in the field "VPN password (pre-shared key)".
  6. Click "Advanced Settings for Network Traffic".
  7. Enable the option "Send all network traffic via the VPN connection".
  8. Click "Apply" to save the settings and on the FRITZ!Repeater, confirm that the procedure may be executed, if you are asked to do so. The internet connection will be cleared briefly and then automatically re-established.

3 Configuring parental controls to allow internet access

If you connected two FRITZ! networks via VPN (LAN-LAN linkup), the device's internet access may not be blocked by the parental controls in one of the FRITZ! networks. Therefore, make sure that the device has unrestricted internet access:

  1. Click "Internet" in the user interface of the FRITZ!Box or the FRITZ!Repeater.
  2. Click "Filter" in the "Internet" menu.
  3. Click on the "Parental Controls" tab.
  4. Check whether the device that is to access the internet via the VPN connection is displayed in the list of home network devices.
  5. If the device is displayed, click "Change Access Profiles" and select the access profile "Unrestricted" for the device or configure the access profile used by the device so that the device can access the internet.
    • If the device is not displayed, then the device uses the "standard" access profile. In this case, configure the "standard" access profile so that the device can access the internet.
  6. Click "Apply" to save the settings.

4 Deleting a VPN connection and reconfiguring it

If you still cannot access the internet over the VPN connection, then the VPN connection is configured incorrectly, for example due to a typing error, an incorrect MyFRITZ! address, or errors made when editing the settings file. Therefore, reconfigure the VPN connection:

  1. Delete the VPN connection on the device and in the user interface of the FRITZ!Repeater.
  2. Reconfigure the VPN connection in the FRITZ!Repeater. Proceed as described in the corresponding guide:



Similar errors:

Language selection